Aaron's Worthless Words

Sign in Subscribe

ios

Configuring Fault Tolerance on the CSM

Like (nearly) everything in the Cisco world, you can set up your CSM to fail over to another module when the primary dies a horrible death. You can have two in the same chassis or even have them in separate chassis — the process is the same no matter how you

Setting Up System Logging on an IOS Device

I like logging on an IOS device. I like to look at the buffer and tell you that your interface went down 30 seconds ago. I like to look on the box and see that BGP with my Internet provider has been flapping since 02:13ET. I like to look

Using the Pipe in IOS

A lot of IOS commands give you a lot of information. Most of the time, though, it’s way too much information, and it sure would be nice to do some grep-like stuff on the output, right? Well, just like on Linux, you can use the pipe (|) to do such.

QoS Policing

We covered QoS tagging the other day, but that just marks packets. I think you’re old enough now that we should actually do some policing. Policing is where you restrict the amount of bandwidth that a flow or set of flows can use. For example, say you have a

Qos Tagging

I’ve been trying to get some experience on Cisco VOIP, and, as you probably know, Quality of Service (QoS) is quite important in that realm. Since VOIP is very time-sensitive, you have to be sure your gear delivers the voice packets first. A packet in an HTTP transaction can